Printer Toner

Chipjet

Chipjet

Printer Toner

Color tank is usually used in inkjet printers, as an important part of components in the print machine, it is hardly possible for it to disengage from the printer, especially when the printer is completely empty. The ink monitor, however, is able to support and surveillance the tank to work, so that as long as the monitor is allocated to the system, the printer can successfully operated.

Sometimes, when you noticed that your printer had displayed “empty” on its screen, it means the ink of the printer is in great need of refilling. The screen can be slightly different if the printer is MP or MG as the message will be shown on the LED screen.

For Canon Inkjet Printer, the electronic chip needs particular care as the precise technology formulates the basic protocol for the printer. Canon Inkjet Printer is widely applied in most of modern offices and workplaces, due to its professional printing technology, the Canon product is highly praised. The ink monitor in the Canon Inkjet Printer t is inevitably for you to run into the chip crash problem during use, so how to disable your ink level monitor becomes the real concern. This guide below is ready to teach you to disable your level monitor in the right way.

The guide will be presented by various steps to help you to disable the monitor in success. However, depending on different types of printers that will verify the customer needs, the messages might face a little bit of variations.

The screenshot is an extraordinary mode to enable the ink tank to disengage. There are four ink tanks: C, M, BK, PK and Canon iP4200 is a great example to test the ink tank disengagement. The following steps will lead you to how to manage to disable the ink tank gradually.

Firstly, if you notice there is a message that included in the screenshot above, the “OK” is the option you should click, then another message will be presented.

Next, please click the “YES” to move to the second message which is a warning one to remind you to see the next screenshot. What you need to do is to click on the “YES” option to the final step straightforward. 

Now, the RESUME button is needed for you to press to help you clear the errors. It may require five to seven seconds of waiting time. However, not all printers have this button, if you can’t find this button on your printer, you are advised to press down and hold the Stop or Cancel button instead. Please remember, you have to hold down the button until the error message stop flashing on the screen.

Your printer is supposed to be normal since all the steps above were applied. But, sometimes, the printer is inevitably run into a delay as the message could be slowly shown. The monitor taskbar which is at the bottom of the screen will then present a message which reads“The ink cartridge has been installed or replaced. If the printout contains misaligned lined or is not satisfactory after the installation or replacement, refer to the user’s guide and carry out the print head alignment.”

Please click the “OK” button as soon as the message is jumped out.

Please note that you need to repeat the steps for all your ink tanks respectively because the printer will register them as “empty”. You will never disable the ink monitors without the ink was registered. Besides, the Canon ink-chip resetters are designed to solve the problem that the printer is on the condition when you can’t deal with the pause. If you want to use an ink resetter, make sure to match the printer match the resetter beforehand.

 

 

 

 

Maxim-Printing

Share:

Share on facebook
Facebook
Share on twitter
Twitter
Share on pinterest
Pinterest
Share on linkedin
LinkedIn

Leave a Reply

Your email address will not be published. Required fields are marked *

On Key

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *